HEIDENHAIN MANUALplus 4110 - Manual (Page 459)

HEIDENHAIN MANUALplus 4110 459
9.1 W
o
rk
ing with MANU
ALplus
Setting up the machine
Prerequisite: Tools T1, T2, and T3 are entered.
Clamp the workpiece blank
Insert the reference tool and specify
the machine data in "Set T, S, F."
Prepare for setting the workpiece zero point and
measuring the tools (in Manual mode with
handwheels / jog controls):
„ Machine an end face.
„ Prepare the diameter.
Set the workpiece zero point
Select "Setup."
Press "Set axis values."
Touch the end face and define this
coordinate as the workpiece zero
point.
Measure tool (for all tools):
Insert the tool and define the T
number in "Set T, S, F."
Press Measure tool.
Touch the diameter and enter the value as
"Measuring point coordinate X."
Touch the end face and enter "0" as "Measuring point
coordinate Z." (The end face has now been defined as
the workpiece zero point.)
Setting up the machine