HEIDENHAIN MANUALplus 4110 - Manual (Page 46)

46 3 Machine Mode of Operation
3.3 Mac
h
ine D
a
ta
3.3 Machine Data
Input and display of machine data
In Manual mode, the machine data for tool, spindle
speed and feed rate are entered in "Set T, S, F ." In
cycle programs the machine data are included in the
cycle parameters, and in DIN programs they are part
of the NC program.
In "Set T, S, F" you also define the "maximum speed"
and the "stopping angle."
You can store the cutting data (spindle speed, feed
rate) together with the tool data and transfer them
with the S, F from tool soft key (see “Tool Data—
Supplementary Parameters” on page 426).
Machine data display
Select "Set T, S, F" (only available in
Manual mode).
Define the parameters.
Conclude data input.
Elements of machine data display
Position display X, Z: Distance between tool tip and workpiece
zero point
„ Letter designating the axis appears in white: Axis "disabled"
Position display C: Position of the C axis
„ Empty box: C axis is not active
„ Letter designating the axis appears in white: Axis "disabled"
Distance-to-go display X, Z, C: The distance remaining from the
current position to the target position of the active traversing
command
Distance-to-go Z and protection zone status: Distance-to-go
display and display of status of protective zone monitoring
Spindle utilization: Utilization of the spindle motor relative to the
rated torque
Spindle utilization and maximum speed: Utilization of the
spindle motor and additional display of valid maximum speed
The machine data display is configurable.
The machine data that appear on your
screen may therefore deviate from the
example shown.
Entering the machine data