HEIDENHAIN MANUALplus 4110 - Manual (Page 398)

398 6 DIN Programming
6.26 Pr
ogr
amming V
a
ri
ables
Precondition for tool information: A tool call must be programmed
for the variables to become effective.
The assignment of variables #519..#521 varies depending on the type
of tool.
# variable Tool information
#514 Tool type:
„ 1: Turning tools
„ 2: Recessing tools
„ 3: Threading tools
„ 4: Drilling tools
„ 5: Taps
„ 6: Milling tools
#515 Tool orientation:
#519 For tool type 6: Number of teeth (K)
#520 For tool type:
„ 1, 2: Cutting radius (R)
„ 6: Milling diameter (I)
#521 For tool type 2: Cutting width (K)
#522 Tool orientation (reference: machining
direction of tool):
„ 0: On the contour
„ 1: To the right of the contour
„ – 1: To the left of the contour
#523..#524 Set-up dimensions (Z, X)
#526..#527 Position of tool tip center I, K (see
figure below)