HEIDENHAIN MANUALplus 4110 - Manual (Page 201)

HEIDENHAIN MANUALplus 4110 201
4.8 Milling Cy
cles
4.8 Milling Cycles
In Teach-in mode these cycles include the activation/
deactivation of the C axis and the positioning of the
spindle.
In Manual mode you can activate the C axis with
"Rapid traverse positioning" and position the spindle
before the actual milling cycle. The milling cycles then
automatically deactivate the C axis.
Milling cycles Symbol
Rapid traverse positioning
Activate C axis; position tool and spindle
Slot axial/radial
For milling single slots or slot patterns
Figure axial/radial
For milling a single figure
Radial/axial ICP contour
For milling single ICP contours or contour
patterns
Face milling
For milling surfaces or polygons
Helical-slot milling, radial
For milling a helical slot
Milling cycles for axial and radial slots,
contours, pockets, surfaces and
polygons.
For pattern machining, see “Drilling/
Milling Patterns” on page 227.
The "constant cutting speed" may only be
programmed with driven tools on
machines with spindle control.