HEIDENHAIN MANUALplus 4110 - Manual (Page 496)

496 9 Examples
9.4 ICP Example "Recessing Cy
cle"
ICP recessing radial
The procedure presupposes that the machine has
been set up and the control is in "Teach-in" mode.
The allowances for pre-cutting are programmed in the
ICP recessing cycle. The cutting width is not entered.
MANUALplus automatically calculates the
proportioning of cuts such that the infeed per pass is
< 80% of the cutting width defined in the tool data
(see figure to the top right).
After defining the cycle parameters, press Edit ICP to
call the ICP programming function. You can now
switch to the input mode by pressing Add element.
First you enter the "rough contour." Then you use the
"superimposition" function to define the roundings.