HEIDENHAIN MANUALplus 4110 - Manual (Page 461)

HEIDENHAIN MANUALplus 4110 461
9.1 W
o
rk
ing with MANU
ALplus
Creating a cycle program
The individual cycles for machining workpieces are
described below. The current working step is
displayed in the workpiece graphic; the cycles and the
cycle parameters are displayed in the graphics to the
right. The machine data display indicates the status
after execution of the cycle.
Sequence of working steps for each cycle:
 Select the cycle.
 Program the cycle.
 Check the cycle by running a graphical simulation.
 Run the cycle.
 Save the cycle.
Roughing cycle 1
First insert the roughing tool.
The cycle machines the area marked in the drawing.
Expanded mode is selected for defining the
allowances.
The "starting point X, Z" is defined such that it is
located shortly before the area to be machined. It is
approached at rapid traverse.
With roughing cycles, the tool returns to the starting
point at the end of the cycle.