HEIDENHAIN MANUALplus 4110 - Manual (Page 505)

HEIDENHAIN MANUALplus 4110 505
9.4 ICP Example "Recessing Cy
cle"
Checking the "ICP recessing radial" cycle
With the graphic simulation function, you can check
the execution of the ICP recessing cycle (Graphics
soft key). Activating the Single block function allows
you to check the paths of traverse more carefully one
block at a time. In the figure to the upper right, the
recessing operation has not been completed yet.
You can then transfer the cycle to the cycle program
with Save or Overwrite.
ICP recessing (finishing)
ICP contour "666" (recess) which was defined in the
above steps is also used for the finishing cycle.