HEIDENHAIN MANUALplus 4110 - Manual (Page 169)

HEIDENHAIN MANUALplus 4110 169
4.6 Thr
ead and Under
c
ut Cy
cles
Parameter combinations for taper angle:
„ X1/Z1, X2/Z2
„ X1/Z1, Z2, W
„ Z1, X2/Z2, W
Cycle run
1 Calculate the proportioning of cuts.
2 Move to starting point X1, Z1.
3 Move to end point Z2 at programmed feed rate.
4 Return on paraxial path and approach for next thread groove.
5 Repeat 3 and 4 for all thread grooves.
6 Approach for next pass, taking the reduced cutting depth and the
"feed angle A" into account.
7 Repeat 3 to 6 until "no. threads D" and "depth U" are reached.