HEIDENHAIN MANUALplus 4110 - Manual (Page 272)

272 5 ICP Programming
5.7 ICP Cont
our Elements on the Lat
e
ra
l Surf
ace
5.7 ICP Contour Elements on the
Lateral Surface
You can use the linear dimension as an alternative to the angular
dimension. The setting of the Polar soft key determines which type of
dimensioning is active. MANUALplus distinguishes angular
dimensions from linear dimensions by different address letters.
„ Depending on the cycle, you can have the MANUALplus
display ICP contours for the face or the lateral surface by
calling the "selection of ICP contours" with the Contour
list soft key.
„ When defining the first element for lateral surface
contours, specify unrolled diameter XS. The linear
dimensions of all subsequent contour elements are
referenced to this diameter.