HEIDENHAIN MANUALplus 4110 - Manual (Page 484)

484 9 Examples
9.3 ICP Example "Matr
ix"
ICP cutting transverse
The procedure presupposes that the machine has
been set up and the control is in "Teach-in" mode.
The infeed depth and the allowances for roughing are
programmed in the ICP cutting cycle. The number of
the ICP contour is entered before calling the ICP
editor (see figure to the top right).
Switch to the ICP programming function with Edit
ICP. In this example, the first two contour elements of
the contour "ICP example Matrix" (ICP contour
number 777) have already been entered.
First you enter the "rough contour." Then you use the
"superimposition" function to define the roundings.
You can now switch to the input mode of the ICP
editor by pressing Insert element (see figure at lower
right).
Since MANUALplus determines the
cutting direction from the contour
direction, the ICP contour must be
described in the negative Z direction.