HEIDENHAIN MANUALplus 4110 - Manual (Page 437)

HEIDENHAIN MANUALplus 4110 437
8.2 P
a
ra
met
e
rs
Tool mount n [MP 601, ..] If you use tool holders in different quadrants, the additional tool
holder is defined as "mirrored“ (see “Tools in different quadrants”
on page 48). The distance between the additional tool holder and
the principal tool holder is usually defined in "compensation X, Z."
„ Compensation in X [mm]
„ Compensation in Z [mm]
„ Type of tool holder
„ 0: Standard
„ 1: Mirrored
General parameters for spindle [MP 805] /
driven tool [MP 855] „ Zero point shift (M19) [°]
The parameter determines the offset in position between the
spindle reference point and the reference point of the angle
encoder (rotary encoder). After receiving the reference pulse
from the rotary encoder, the current actual position is overwritten
by the parameter value.
„ Number of revolutions for chip breaking
Number of additional spindle revolutions for disengaging the tool
during spindle stop.
„ M5/M19 Angle (usually set with "Set T, S, F").
„ Speed value VConstant (G96) (usually set with "Set T, S, F").
„ Speed value NConstant (G97) (usually set with "Set T, S, F").
„ Speed limit (G26) (usually set with "Set T, S, F").
Tolerance values for spindle [MP 806] / driven
tool [MP 856] Configuration parameters
Backlash compensation in linear axis (X) [MP
1107] / linear axis (Z) [MP 1157] The backlash compensation takes into account the "value of
backlash compensation" for every change of direction. This enables
you to compensate for backlash between the speed encoder and
the table when the drive and encoder are connected directly.
„ Type of backlash compensation
„ 0: No compensation
„ 1: Value of backlash compensation is added
„ Value of backlash compensation
Limit switches, protection zone, feed rates for
linear axis (X) [MP 1116] / linear axis (Z) [MP
1166] For linear axis Z (parameter 1166), the value defined in "Set protect.
zone" is transferred.
„ Protection zone dimension negative [mm]
„ Protection zone dimension positive [mm]
„ Feed rate for rapid traverse [mm/min]
„ Reference dimension [mm]
Misalignment compensation in linear axis (X)
[MP 1120] /linear axis (Z) [MP 1170] Configuration parameters
Machine parameters (MP)