HEIDENHAIN MANUALplus 4110 - Manual (Page 132)

132 4 Cycle Programming
4.5 Recessing c
y
cles
Cycle run
1 Calculate the recess positions and the proportioning of cuts.
2 Approach workpiece for next recess from starting point or from
last recess on paraxial path.
3 Move to end point X2 or end point Z2 at programmed feed rate.
4 Remain at this position for dwell time "E."
5 Retract and approach for next pass.
6 Repeat 3 to 5 until the complete recess has been machined.
7 Repeat 2 to 6 until all recesses have been machined.
8 Return to starting point on paraxial path.