HEIDENHAIN MANUALplus 4110 - Manual (Page 356)

356 6 DIN Programming
6.1
8
Dr
illing Cy
cles
Notes:
„ The control starts execution of the cycle at the current tool and
spindle position. The starting point is approached at rapid traverse.
„ Axial hole:
„ Do not program "X."
„ Define "Z."
„ Radial hole:
„ Define "X."
„ Do not program "Z."
„ X and Z are programmed: The control uses the "tool orientation" to
decide whether a radial or an axial hole is machined (see “Drilling
tools” on page 423).