HEIDENHAIN MANUALplus 4110 - Manual (Page 141)

HEIDENHAIN MANUALplus 4110 141
4.5 Recessing c
y
cles
ICP recessing radial/axial, finishing
Call the recessing menu.
Select the "ICP recessing, radial" cycle (see figures at
right).
Select "ICP recessing axial" (see figures on the
following page).
Press the Finishing run soft key.
The cycle finish-machines the number of recesses defined in Q with
the ICP recessing contour. The parameters "X, Z" define the position
of the first recess.
At the end of cycle, the tool returns to the starting point.
Cycle parameters
 X, Z starting point
 I, K oversize X, Z
 N ICP contour number
 DX, DZ distance to subsequent recess with respect to the
preceding recess
 Q number of recess cycles —default: 1
 T tool number
 S spindle speed / cutting speed
 F feed per revolution