HEIDENHAIN MANUALplus 4110 - Manual (Page 148)

148 4 Cycle Programming
4.5 Recessing c
y
cles
Recess turning radial/axial, finishing
Call the recessing menu.
Select the "Recess turning" cycle.
Select the "Recess turning, radial" cycle (see figures
at right).
Select "Recess turning, axial" (see figures on the
following page).
Press the Finishing run soft key.
The cycle finishes the contour area from X, Z to X2, Z2 (see also
“Recess turning” on page 143).
Cycle parameters
 X, Z starting point
 X2, Z2 contour end point
 I, K workpiece-blank oversize X, Z
 T tool number
 S spindle speed / cutting speed
 F feed per revolution
With "oversizes I, K" for the workpiece blank, you define
the material to be machined during the finishing cycle. It is
therefore absolutely necessary to define the oversizes for
recess turning—finishing.