HEIDENHAIN MANUALplus 4110 - Manual (Page 509)

HEIDENHAIN MANUALplus 4110 509
9.5 ICP Example "Milling Cy
cle"
Contour element 1
First you enter the "rough contour." Then you use the
"superimposition" function to define the roundings.
The contour starts with a horizontal line.
The starting point of the ICP contour is defined in "XS,
YS" when programming the first contour element.
The element is defined unambiguously after the
"length of line" has been entered. MANUALplus draws
the contour element in the graphics window.