HEIDENHAIN MANUALplus 4110 - Manual (Page 471)

HEIDENHAIN MANUALplus 4110 471
9.2 ICP Example "Thr
eaded St
ud"
ICP cutting longitudinal
The procedure presupposes that the machine has
been set up and the control is in "Teach-in" mode.
The infeed depth and the allowances for roughing are
programmed in the ICP cutting cycle. In this example,
the number ("888") of the ICP contour is entered
before calling the ICP editor (see figure to the top
right).
You then switch to the ICP editor and press Insert
element to enter the contour elements.
Since MANUALplus determines the
cutting direction from the contour
direction, the ICP contour must be
described in the negative Z direction.