HEIDENHAIN MANUALplus 4110 - Manual (Page 529)

HEIDENHAIN MANUALplus 4110 529
1
0
.3 T
e
c
hnical Inf
o
rm
ation
User functions
Manual operation „ Manually controlled slide movement via intermediate switch or
electronic handwheels
„ Graphically supported entry and execution of cycles in
conjunction with manual machine operation
„ Thread repair function for reworking threads with unclamped and
re-clamped workpieces
Teach-in mode „ Sequential linking of machining cycles
„ Graphic simulation of each machining cycle after completion of
data input
„ Immediate execution after input of cycle
„ Storage of machining cycles with automatic program creation
Program run mode „ Cycle or DIN programs in single-block mode or continuous-run
mode
Programming—machining cycles „ Graphically supported cycle programming in plain language
„ Linear and circular paths, chamfers and roundings
„ Roughing cycles for longitudinal and transverse turning
operations, for simple or complex contours, or contours defined
with ICP
„ Recessing cycles for simple or complex contours, or contours
defined with ICP
„ Recess turning cycles for simple or complex contours, or
contours defined with ICP
„ Undercuts as per DIN76, DIN509E, DIN509F
„ Parting cycle
„ Drilling, deep-hole drilling and tapping cycles
„ Linear and circular hole patterns on face and lateral surface
„ Cycles for single or multiple paraxial and tapered threads
„ Axial and radial milling cycles for slots, figures, single surfaces
and polygons as well as for complex contours defined with ICP
„ Thread milling
„ Use of DIN macros in cycle programs
„ Hole patterns on face and lateral surface
„ Conversion of cycle programs into DIN programs
Interactive contour programming (ICP) „ Straight line in 3 principal axes (max. ±10 m)
„ Circle in 2 axes (max. ±100 m)
DIN programming „ NC programming as per DIN 66025 (ISO 6983)
„ Creation of DIN programs or DIN macros
„ Programming with roughing, recessing, recess-turning, drilling
and milling cycles
„ Simple geometry programming (calculation of missing data)
„ Programming variables
„ Subprograms