HEIDENHAIN MANUALplus 4110 - Manual (Page 113)

HEIDENHAIN MANUALplus 4110 113
4.4 Roughing Cy
cles
Finishing plunge, longitudinal/transverse
Call the "Roughing, longitudinal/transverse" cycles.
Select "Plunge longitudinal" (see figures at right).
Select "Plunge transverse" (see figures on the
following page).
Press the Finishing run soft key.
The cycle finishes the contour area from X1, Z1 to X2, Z2. At the end
of cycle, the tool returns to starting point X, Z.
Cycle parameters
 X, Z starting point
 X1, Z1 contour starting point
 X2, Z2 contour end point
 A plunging angle (default: 0°): Range: 0° <= A < 90°
 W end angle: Oblique cut at contour end—Range: 0° <= W < 90°
 T tool number
 S spindle speed / cutting speed
 F feed per revolution
„ The steeper the tool plunges into the material, the
greater the feed rate decrease (max. 50%).
„ Pay attention to the dimensions of facing tools (see
“Facing tools” on page 419).
Danger of collision!
If the tool angle and the tool point angle have not been
defined, the tool plunge-cuts at the plunging angle. If the
tool and point angles have been defined, the tool plunge-
cuts at the maximum possible plunging angle. In this case,
the resulting contour will not be completely finished and
may need to be reworked.