HEIDENHAIN MANUALplus 4110 - Manual (Page 325)

HEIDENHAIN MANUALplus 4110 325
6.13 Recessing Cy
cles
Note on the execution of the cycle:
„ MANUALplus determines the cutting direction from the current tool
position relative to the starting point / end point of the contour area.
„ Tool position at the end of the cycle: Cycle starting point
Example: G861
%861.nc
[G861]
N1 T38 G95 F0.15 G96 S200 M3
N2 G0 X110 Z2
N3 G861 I1 K0.2 Q1
N4 G0 X100 Z2
N5 G1 Z-6 B3
N6 G1 X88 B2
N7 G1 Z-13 A-20 B2
N8 G1 X60 B3
N9 G1 Z0 B-1
N10 G1 X55
N11 G80
END
Example: G862
%862.nc
[G862]
N1 T30 G95 F0.15 G96 S200 M3
N2 G0 X87 Z-35
N3 G862 I0.5 Q1 E0.11
N4 G0 X85 Z-29.5
N5 G1 X84 Z-30
N6 G1 X75 A-75 B2
N7 G1 Z-42 B-1
N8 G1 X70
N9 G1 Z-58.5 B3
N10 G1 X85 Z-63 B-2
N11 G1 Z-66
N12 G80
END
„ Cutting radius compensation: Active.
„ G57/G58 oversizes are taken into account if I/K is not
programmed. After the cycle has been executed, the
oversizes are canceled.