HEIDENHAIN MANUALplus 4110 - Manual (Page 196)

196 4 Cycle Programming
4.7 Dr
illing Cy
cles
Cycle run
1 Position spindle to "spindle angle C" (in Manual mode, machining
starts from the current spindle angle).
2 If defined, move at rapid traverse to
„ Z1 (axial).
„ X1 (radial).
3 Tap thread to
„ End point Z2 (axial).
„ End point X2 (radial).
4 If X1/Z1 has been defined, retract at return speed SR to
„ Starting point of hole Z1 (axial).
„ Starting point of hole X1 (radial).
If X1/Z1 has not not been defined, retract to
„ Starting point Z (axial).
„ Starting point X (radial).