HEIDENHAIN MANUALplus 4110 - Manual (Page 329)

HEIDENHAIN MANUALplus 4110 329
6.13 Recessing Cy
cles
Recessing finishing, axial G867 / radial G868
The cycles axially/radially finish the contour area described by the tool
position and "X, Z."
Tool position at the end of the cycle: Cycle starting point
Parameters
 X base corner X (diameter value)
 Z base corner Z
 E finishing feed (default: Active feed rate)
Note on the execution of the cycle:
„ Tool position at the end of the cycle: Cycle starting point
Example: G867
%867.nc
[G867]
N1 T38 G95 F0.15 G96 S200 M3
N2 G0 X120 Z1
N3 G867 X102 Z-4 E0.11
END
Example: G868
%868.nc
[G868]
N1 T30 G95 F0.15 G96 S200 M3
N2 G0 X62 Z-18
N3 G868 X54 Z-30 E0.12
END
Cutting radius compensation: Active.