HEIDENHAIN MANUALplus 4110 - Manual (Page 69)

HEIDENHAIN MANUALplus 4110 69
3.9 Gr
ap
hic Simulation
The motion simulation depicts the workpiece blank
material as a "filled surface" and "machines" it during
simulation by "erasing" the material (erasing graphics).
The tools move at the programmed feed rate
(program-run graphics).
If during running simulation you switch to the motion
simulation, it will not become effective until the
simulation function is restarted.
You can interrupt the motion simulation at any time,
even during simulation of an NC block. The display
below the simulation window indicates the target
position of the current path.
When using the motion simulation for checking
individual cycles, please note that in some cycles the
workpiece blank is not known. The tool movements
will then be displayed, but the machining process will
not be displayed.