HEIDENHAIN MANUALplus 4110 - Manual (Page 229)

HEIDENHAIN MANUALplus 4110 229
4.9 Dr
illing/Milling P
a
tt
er
ns
Cycle parameters
 X, Z starting point
 C spindle angle (C-axis position)—default: Current spindle angle
 X1, C1 starting point of pattern: Position, starting angle (polar
coordinates)
 XK, YK starting point of pattern: (Cartesian coordinates)
 I, J end point of pattern (Cartesian coordinates)
 Ii, Ji pattern spacing (incremental)
 Q number of holes/slots —default: 1
 T tool number
 S spindle speed / cutting speed
 F feed per revolution
MANUALplus also interrogates the parameters that are required for
machining the respective elements.
Use the following parameter combinations to define the:
„ Starting point of pattern
„ X1, C1 or
„ XK, YK
„ Pattern positions:
„ Ii, Ji and Q
„ I, J and Q
Cycle run
1 Positioning (depending on the machine configuration):
„ Without C axis: Position to "spindle angle C."
„ With C axis: Activate C axis and position to "spindle angle C" at
rapid traverse.
„ Manual mode: Machining starts from current spindle angle.
2 Calculate the pattern positions.
3 Position to starting point of pattern.
4 Execute drilling/milling operation.
5 Position for next machining operation.
6 Repeat steps 4 and 5 until all machining operations have been
completed.
7 Return to starting point X, Z.