HEIDENHAIN MANUALplus 4110 - Manual (Page 421)

HEIDENHAIN MANUALplus 4110 421
7.
4 T
ool D
a
ta
Recessing and recess-turning tools
Select recessing tools.
Tool parameters
 X setup dimension in X
 Z setup dimension in Z
 R cutting radius
 WO tool orientation: For code number, see graphic support
window
 K cutting width
 DX wear compensation in X: Range: –100mm < DX < 100mm
 DZ wear compensation in Z: Range: –100mm < DZ < 100mm
 DS special compensation: Range: –100mm < DS < 100mm
 Q tool text: Reference to tool text
 MD direction of rotation —default: Not defined
„ 3: M3
„ 4: M4
 TS cutting/spindle speed: default: Not defined
 TF feed rate —default: Not defined
 PT tool life —default: Not defined
 RT: Display field for remaining tool life
 PZ quantity —default: Not defined
 RZ: Display field for remaining quantity
„ With recessing tools, you define the position of the
reference point with "tool orientation WO."
„ "DX, DZ" compensate for wear on the two sides of the
tool tip that lie next to the reference point. "DS"
compensates for wear on the third side of the tool tip
(see figure at right).
„ The "cutting width K" is evaluated if the corresponding
parameter is not defined in the recessing cycle.