HEIDENHAIN MANUALplus 4110 - Manual (Page 66)

66 3 Machine Mode of Operation
3.8 Pr
ogr
am Run Mode
MANUALplus manages 16 additive compensation values as
"parameters." You can edit the additive compensation values in the
"Organization mode of operation—Current parameters." Additive
compensation values need to be activated with "G149" in a DIN
program or a DIN macro.
Setting compensation values with the
handwheel
Interrupt program run with Cycle Stop
Press Tool correct.
Select X offset for tool (or Z offset for tool).
The compensation values that you determine per
handwheel are now shown in the "Distance-to-go"
display.
Transfer the compensation value to the tool table.
The T display shows the new compensation value.
The distance-to-go display is cancelled.
Interrupt program run with Cycle Stop
Select Tool correct.
Select Erase X offset (or Erase Z offset) for the
entered compensation value to be deleted.
The “Compensation values via handwheel” function is
only available if bit 13 of the configuration code (MP 18
– control configuration) is set.
Entering tool compensation values with the handwheel
Deleting tool compensation values