HEIDENHAIN MANUALplus 4110 - Manual (Page 52)

52 3 Machine Mode of Operation
3.4 Mac
h
ine Set
u
p Defining the tool change position
With the cycle "Move to tool change position" or the DIN command
G14, the slide moves to the tool change point. Always program the
tool change point as far from the workpiece as possible to avoid
damage to the workpiece during tool change.
Select "Setup."
Press "Tool change point."
Approach the tool change position.
Move to the tool change point using the jog keys or the handwheel.
Define this position as tool change point.
Defining the tool change position
The coordinates of the tool change position are entered
and displayed as distance between machine zero point
and tool carrier zero point. As these values are not
displayed, it is advised to approach the tool change point
and then to define the parameters using Take over
position.