HEIDENHAIN MANUALplus 4110 - Manual (Page 482)

482 9 Examples
9.2 ICP Example "Thr
eaded St
ud"
Checking the ICP finishing cycle
With the graphic simulation function, you can check
the execution of the ICP finishing cycle (Graphics soft
key). You can then transfer the cycle to the cycle
program with the Save or Overwrite.
MANUALplus finishes the contour in the defined
"contour direction" (see figure to the top right).
Cycle program "ICP example workpiece"
Besides the ICP cycles, the created cycle program
also includes the positioning cycles for tool change
and the thread cycle (see figure to the lower right).
Functions of the cycles:
„ N1: Remove the material (roughing).
„ N2: Position the tool for tool change.
„ N3: Finish-machine the workpiece.
„ N4: Position the tool for tool change.
„ N5: Machine the thread.
„ N6: Position the tool for removing the workpiece.