HEIDENHAIN MANUALplus 4110 - Manual (Page 273)

HEIDENHAIN MANUALplus 4110 273
5.7 ICP Cont
our Elements on the Lat
e
ra
l Surf
ace
Entering lines on the lateral surface
Select the line direction.
You enter the dimensions of the line and then define the transition to
the next contour element.
Parameters
 ZS, YS starting point (YS as linear dimension—reference:
diameter XS)
 CS starting point as angular dimension
 XS unrolled diameter
 Z target point
 CY target point as linear dimension (reference: diameter XS)
 C target point as angular dimension
 L length of line
 F special feed
Select the line direction.
You enter the dimensions of the line and then define the transition to
the next contour element.
Parameters
 ZS, YS starting point (YS as linear dimension—reference:
diameter XS)
 CS starting point as angular dimension
 XS unrolled diameter
 Z target point
 CY target point as linear dimension (reference: diameter XS)
 C target point as angular dimension
 A angle to Z axis —for direction of angle, see graphic support
window
 L length of line
 F special feed
Vertical/horizontal lines
Line at angle