HEIDENHAIN MANUALplus 4110 - Manual (Page 139)

HEIDENHAIN MANUALplus 4110 139
4.5 Recessing c
y
cles
ICP recessing cycles
Call the recessing menu.
Select the "ICP recessing, radial" cycle (see figures at
right).
Select "ICP recessing axial" (see figures on the
following page).
The cycle machines the number of recesses defined in Q with the ICP
recessing contour. The parameters "X, Z" define the position of the first
recess.
Cycle parameters
 X, Z starting point
 P recessing width: Infeeds <= P
„ No input: P = 0.8 * cutting width of the tool
 I, K oversize X, Z
 N ICP contour number
 DX, DZ distance to subsequent recess with respect to the
preceding recess
 Q number of recess cycles —default: 1
 T tool number
 S spindle speed / cutting speed
 F feed per revolution