HEIDENHAIN MANUALplus 4110 - Manual (Page 105)

HEIDENHAIN MANUALplus 4110 105
4.4 Roughing Cy
cles
Finishing cut, longitudinal/transverse
Call the "Roughing, longitudinal/transverse" cycles.
Select "Cut longitudinal" (see figures at right).
Select "Cut transverse" (see figures on the following
page).
Press the Finishing run soft key.
The cycle "Finishing cut, longitudinal" finishes the contour area from X1
to Z2.
The cycle "Finishing cut, transverse" finishes the contour area from Z1
to X2.
At the end of cycle, the tool returns to the starting point.
Cycle parameters
 X, Z starting point
 X1 contour starting point (finishing cut, longitudinal)
 Z2 end point of contour (finishing longitudinal)
 Z1 contour starting point (finishing transverse)
 X2 end point of contour (finishing transverse)
 T tool number
 S spindle speed / cutting speed
 F feed per revolution
Execution of "Finishing cut, longitudinal" cycle
1 Move in transverse direction from X, Z to contour starting point X1.
2 Finish first in longitudinal direction, then in transverse direction.
3 Return in longitudinal direction to starting point.