HEIDENHAIN MANUALplus 4110 - Manual (Page 439)

HEIDENHAIN MANUALplus 4110 439
8.2 P
a
ra
met
e
rs
Simulation: Settings [SP 27] The machining simulation is delayed by the “path delay” time after
the path has been simulated graphically. The simulation speed can
thus be influenced.
„ Path delay
Allocation to interfaces [SP 40]
Interface 1 [SP 41]
Interface 2 [SP 42] MANUALplus stores the "settings" of the serial interface in these
parameters. The parameters are usually defined in "Transfer—
Settings" (see “Settings in the "Serial" and "Printer" modes” on
page 445).
Transfer directory [SP 48] The parameters are usually defined in "Transfer—Settings" (see
“Settings in "Network" mode” on page 444).
„ PCDIRECT directory: Path of directory offered and indicated for
data transfer with PCDIRECT.
„ NETWORK directory: Path of directory offered and indicated for
data transfer with NETWORK.
Display type 1, manual control [SP 301] With these parameters, you can configure your machine display.
(The arrangement of the machine display fields and code numbers
of the display symbols are described in the following tables.)
„ Symbol for field 1: Enter the code number of the symbol
„ Slide/spindle: Enter "0".
„ Component group: Enter "0".
„ Symbol for field 2
„ . . .
Control parameters (SP)
Arrangement of the machine display fields
Field 1 Field 4 Field 7
Field 2 Field 5 Field 8
Field 3 Field 6 Field 9
Code numbers of the machine display symbols Code numbers of the machine display symbols
0 Special code, no display 60 Actual/nominal
value of spindle
1 Actual X-position
display 61 Spindle and speed
information