HEIDENHAIN MANUALplus 4110 - Manual (Page 91)

HEIDENHAIN MANUALplus 4110 91
4.3 Single Cut Cy
cles
Linear machining, longitudinal
Call the single-cut menu.
Select the "Longitudinal linear machining" cycle.
With return soft key:
Off: When the cycle is completed, the tool remains at
the cycle end position.
On: Tool returns to the starting point.
Longitudinal linear machining
The tool moves from the starting point to the contour end point at the
programmed feed rate and remains at the cycle end position.
Contour linear, longitudinal ("With return")
The tool approaches the workpiece, executes the longitudinal cut and
returns to the starting point at the end of cycle (see figures at right).
Cycle parameters
 X, Z starting point
 X1 contour starting point
 Z2 contour end point
 T tool number
 S spindle speed / cutting speed
 F feed per revolution
Cycle run (if "With return" is active)
1 Move from X, Z to contour starting point X1.
2 Move to contour end point Z2 at programmed feed rate.
3 Retract and return to starting point on paraxial path.