HEIDENHAIN MANUALplus 4110 - Manual (Page 286)

286 6 DIN Programming
6.2 Editing DIN Pr
ogr
a
ms
Menu structure
Select the function group by menu key.
„ G and M functions: The function number and further
parameters that vary depending on the function are
entered subsequently.
„ Comment, subprogram and T, S, F: The required
parameters are entered subsequently.
„ Variable functions: MANUALplus switches to other
menus for entering further data.
DIN functions Menu key
G function
Traversing commands, cycles, and other G
commands.
M function
Switching functions for machine components and
program control functions (see “M Functions” on
page 408).
Machine data
Entry of F, S, T (see “Set T, S, F” on page 392).
Comment
Entry of comments (see “Editing DIN Programs” on
page 281).
Program variable functions
Switch to the "Program variable menu" (see
“Programming Variables” on page 396).
Machine variable functions
Switch to the "Machine variable menu" (intended for
special cases and of no importance to the DIN
programmer).
Subprogram call
Program a subprogram call (see “Subprograms” on
page 406).