HEIDENHAIN MANUALplus 4110 - Manual (Page 261)

HEIDENHAIN MANUALplus 4110 261
5.5 ICP Cont
our Elements, T
u
rn
ing Cont
our
Select the line direction.
You enter absolute or polar dimensions for the line and then define the
transition to the next contour element. The direction of the angle is
shown in the graphic support window.
Parameters
 XS, ZS starting point in X/Z (= end point of last element)
 X, Z target point in X/Z
 Xi, Zi target point in X/Z (incremental): Distance from starting
point to target point
 L length of line
 A angle to Z axis
 F special feed
Line at angle