HEIDENHAIN MANUALplus 4110 - Manual (Page 285)

HEIDENHAIN MANUALplus 4110 285
6.2 Editing DIN Pr
ogr
a
ms
Block functions
Mark several successive NC blocks (block sequence)
to be able to cut, copy or delete them. If you cut or
copy the block sequence, it is taken into the clipboard.
You can then insert this block sequence at a different
position in the program, or call a different DIN
program and insert the block sequence there. The
block sequence remains stored in the clipboard until it
is overwritten or MANUALplus is switched off.
Position the cursor on the beginning of a block.
Call the block functions.
Mark the beginning of the block.
Position the cursor on the end of a block.
Mark the end of the block.
Copy the block and transfer it to the
clipboard.
Cut the block out and transfer it to the
clipboard.
Load a new DIN program (if required).
Place the cursor on the position where the block is to
be inserted.
Transfer the block sequence from the
clipboard (the NC blocks are inserted
below the cursor).
Copying and pasting blocks