HEIDENHAIN MANUALplus 4110 - Manual (Page 446)

446 8 Organization Mode of Operation
8.3 T
ransf
er
Transferring programs (files)
When selecting a program, place the highlight on the
desired program and press Mark. You can also select
all programs with Mark all.
„A marked program is indicated with a diamond. To
unmark a program, simply press Mark once again.
If you want to transfer a single program, place the
highlight on the program and press Transmit file or
Receive file.
Below the window, MANUALplus displays the file
size of the highlighted program and the time it was
last changed.
With DIN programs / DIN macros, you can also view
the NC program with Program view.
Parameters and tool data are sent/received as
"blocks."
During transfer, MANUALplus displays the following
information in a "transfer window" (see figure at
bottom right):
„ The transfer status in the form of a small red square,
which moves between the control and the PC
during transfer—if transfer is interrupted, the red
square remains stationary.
„ The name of the program which is currently being
transferred.
„ Amount of data already transferred is shown in the
progress window.
„ When receiving parameters and tool
data, the previous data are
overwritten.
„ When you start "Network,"
MANUALplus reads the program
names and program descriptions of the
remote station. This process can take
several minutes and is indicated in the
"progress display" above the soft-key
row.