HEIDENHAIN MANUALplus 4110 - Manual (Page 419)

HEIDENHAIN MANUALplus 4110 419
7.
4 T
ool D
a
ta
Lathe tools
Select lathe tools.
The graphic support window illustrates how goose-necked roughing
and finishing tools for longitudinal machining are dimensioned (WO 1,
3, 5 and 7). On the next page you will find information on the
dimensions of facing tools, neutral tools and button tools.
Tool parameters
 X setup dimension in X
 Z setup dimension in Z
 R cutting radius
 WO tool orientation: For code number, see graphic support
window
 A tool angle: Range: 0° <= A <= 180°
 B point angle: Range: 0° <= B <= 180°
 DX wear compensation in X: Range: –100mm < DX < 100mm
 DZ wear compensation in Z: Range: –100mm < DZ < 100mm
 Q tool text: Reference to tool text
 MD direction of rotation —default: Not defined
„ 3: M3
„ 4: M4
 TS cutting/spindle speed: default: Not defined
 TF feed rate —default: Not defined
 PT tool life —default: Not defined
 RT: Display field for remaining tool life
 PZ quantity —default: Not defined
 RZ: Display field for remaining quantity
Facing tools
The figure at right explains how to dimension these tools, taking facing
tools with the tool orientations WO=1 and WO=7 as an example.