HEIDENHAIN MANUALplus 4110 - Manual (Page 424)

424 7 Tool Management Mode
7.
4 T
ool D
a
ta
Tapping tools
Select tapping tools.
Tool parameters
 X setup dimension in X
 Z setup dimension in Z
 I diameter of thread
 WO tool orientation: For code number, see graphic support
window
 F thread pitch
 DX wear compensation in X: Range: –100mm < DX < 100mm
 DZ wear compensation in Z: Range: –100mm < DZ < 100mm
 Q tool text: Reference to tool text
 H tool driven —default: 0
„ 0: Not driven
„ 1: Driven
 MD direction of rotation —default: Not defined
„ 3: M3
„ 4: M4
 TS cutting/spindle speed: default: Not defined
 TF feed rate —default: Not defined
 PT tool life —default: Not defined
 RT: Display field for remaining tool life
 PZ quantity —default: Not defined
 RZ: Display field for remaining quantity
„ The "thread pitch K" is evaluated if the corresponding
parameter is not defined in the tapping cycle.
„ Using the parameter "driven tool H," MANUALplus
determines whether a driven tool is being used.