HEIDENHAIN MANUALplus 4110 - Manual (Page 458)

458 9 Examples
9.1 W
o
rk
ing with MANU
ALplus
9.1 Working with MANUALplus
The following example illustrates how to set up the machine and how
to machine a workpiece using the cycle programming feature. The
machining operation is to be performed in Teach-in mode. This has the
advantage that, once you have machined the first workpiece, you have
a cycle program that can be repeated any time.
Required tools
„ Roughing tool:
„ Position T1
„ WO = 1 Tool orientation
„ A = 93° Setting angle
„ B = 55° Nose angle
„ R = 0.8 Tool radius
„ Finishing tool:
„ Position T2
„ WO = 1 Tool orientation
„ A = 93° Setting angle
„ B = 55° Nose angle
„ R = 0.8 Tool radius
„ Threading tool:
„ Position T3
„ WO = 1 Tool orientation
Sequence of working steps
 Clamp a workpiece blank (diameter 60 mm, length 100 mm).
 Machine setup
– Define the workpiece zero point
– Measure the tool dimensions
 Switch to "Teach-in" mode.
 Machine the workpiece cycle by cycle.