HEIDENHAIN MANUALplus 4110 - Manual (Page 504)

504 9 Examples
9.4 ICP Example "Recessing Cy
cle"
Rounding the corners
The rounding arcs are "superimposed" on the existing
contour. Then select the corner (Next corner/
Previous corner). Following that, define the
"rounding radius B." MANUALplus inserts the
rounding in the existing ICP contour and draws the
"perfected" contour.
MANUALplus offers the next contour corner for
selection. In this example, all existing corners need to
be rounded.
The ICP contour is completely programmed (see
figure at lower right). Back concludes ICP
programming and Input finished concludes the ICP
cycle.