HEIDENHAIN MANUALplus 4110 - Manual (Page 323)

HEIDENHAIN MANUALplus 4110 323
6.12 Simple T
u
rn
ing Cy
cles
Line with chamfer G88
G88 machines chamfers at orthogonal, paraxial outside corners. A
preceding longitudinal or transverse element is machined if the tool is
located at the X or Z coordinate of the corner before the cycle is
executed. The chamfers are machined in one pass.
MANUALplus determines the direction of the chamfer from the "tool
orientation" (see “Lathe tools” on page 419).
Tool position at the end of the cycle: End point of chamfer
Parameters
 X corner point (diameter value)
 Z corner point
 B chamfer width
 E reduced feed rate: default: Active feed rate
Example: G88
%88.nc
[G88]
N1 T3 G95 F0.25 G96 S200 M3
N2 G0 X70 Z2
N3 G1 Z0
N4 G88 X84 Z0 B2
N5 . . .
END
„ Cutting radius compensation: Active.
„ Oversizes: are not taken into account.