HEIDENHAIN MANUALplus 4110 - Manual (Page 431)

HEIDENHAIN MANUALplus 4110 431
8.2 P
a
ra
met
e
rs 8.2 Parameters
Parameters that are preset for the usual "daily
operations" are grouped under the menu item
Cur.(rent) para(meters) [1].
Selecting this menu item calls the following:
„ Setup (menu) [1]
„ Machine parameters [2]
„ NC switches [3]
„ PLC parameters [4]
„ Graphics parameters [5]
„ Machining [6]
A small arrow to the right of the menu line indicates
that a menu item has a submenu (see figure to the top
right). After you have selected a parameter, the input
window is opened.
Alternately, some parameters can be set in the
Machine mode of operation.
You can call the Config(uration parameters) [2]
menu item only with "system manager" authorization
(see “Access authorization” on page 453).
Displaying and editing parameters
A parameter consists of a number of parameter
values. The parameter values are displayed and edited
in one or several input windows.
The title bar of the input window indicates the
parameter designation and the number of windows.
Each parameter value is explained by the text next to
the input field.
For "current parameters" which refer to a slide or a
spindle, the number of the slide or spindle is displayed
to the bottom left. With configuration parameters, the
parameter number is displayed to the bottom left.
The parameter editor automatically considers the
metric or inch units of measure.
Some parameters are reserved for
authorized service and commissioning
personnel.