HEIDENHAIN MANUALplus 4110 - Manual (Page 495)

HEIDENHAIN MANUALplus 4110 495
9.4 ICP Example "Recessing Cy
cle"
9.4 ICP Example "Recessing Cycle"
This example illustrates the use of an ICP recessing cycle. The
individual working steps for machining the ICP contour and integrating
the contour into ICP cycles are based on the workpiece drawing.
In the process described below, you create an ICP contour description
and a cycle program for parts production.
The machining operation is performed with the "ICP recessing radial"
cycle.
Required tool
„ Recessing tool:
„ Position T4
„ WO = 1 Tool orientation
„ R = 0.2 Tool radius
„ K = 5 Cutting width
Sequence of working steps
 Clamp a workpiece blank (diameter 60 mm, length 65 mm).
 Machine setup
– Define the workpiece zero point
– Measure the tool dimensions
 Switch to "Teach-in" mode.
 Enter the positioning cycles for tool change.
 Call the "ICP cut radial" cycle.
 ICP contour programming.
 Integrate the ICP contour in the recessing, finishing cycle.