HEIDENHAIN MANUALplus 4110 - Manual (Page 150)

150 4 Cycle Programming
4.5 Recessing c
y
cles
Recess turning radial/axial, finishing—Expanded
Call the recessing menu.
Select the "Recess turning" cycle.
Select the "Recess turning, radial" cycle (see figures
at right).
Select "Recess turning, axial" (see figures on the
following page).
Press the Expanded soft key.
Press the Finishing run soft key.
The cycle finishes the contour area from X1, Z1 to X2, Z2 (see also
“Recess turning” on page 143).
Cycle parameters
 X, Z starting point
 X1, Z1 contour starting point
 X2, Z2 contour end point
 O recessing feed rate —default: Active feed rate
 A starting angle: Range: 0° <= A < 90°
 W end angle: Range: 0° <= W < 90°
 R rounding
 B1, B2 chamfer/rounding (B1 contour start; B2 contour end)
„ B>0: Radius of rounding
„ B<0: Width of chamfer
 RB depth compensation
 T tool number
 S spindle speed / cutting speed
 F feed per revolution
 I, K workpiece-blank oversize X, Z