HEIDENHAIN MANUALplus 4110 - Manual (Page 506)

506 9 Examples
9.4 ICP Example "Recessing Cy
cle"
Checking the "ICP recessing radial, finishing" cycle
With the graphic simulation function, you can check
the execution of the ICP recessing, finishing cycle
(Graphics soft key). In the figure to the upper right,
the finishing operation has not been completed yet.
You can then transfer the cycle to the cycle program
with Save or Overwrite.
Cycle program "ICP recessing example"
Besides the ICP cycles, the created cycle program
also includes the positioning cycles for tool change
(see figure to the right).
Functions of the cycles:
„ N1: Contour recessing.
„ N2: Contour finishing.
„ N3: Position the tool for removing the
workpiece.