HEIDENHAIN MANUALplus 4110 - Manual (Page 253)

HEIDENHAIN MANUALplus 4110 253
5.3 Impor
ting of DXF Cont
ours
„ Maximum distance: The DXF import sets the starting point to
one of the two contour points farthest apart from each other. The
program automatically determines which of these points is the
starting point. It is not possible to influence this decision.
„ Marked point: If one of the contour points in the DXF drawing is
marked with a complete circle, then this point is specified as the
starting point. The contour point must be at the center of the
complete circle.
„ Direction of rotation: Indicate whether the contour is aligned in
clockwise or counterclockwise direction.