HEIDENHAIN MANUALplus 4110 - Manual (Page 147)

HEIDENHAIN MANUALplus 4110 147
4.5 Recessing c
y
cles
By setting the following optional parameters, you can define
additional contour elements:
„ A: Oblique cut at contour start
„ W: Oblique cut at contour end
„ R: Rounding (in both corners of the contour valley)
„ B1: Chamfer/Rounding at contour start
„ B2: Chamfer/Rounding at contour end
Cycle run
1 Calculate the proportioning of cuts.
2 Approach workpiece for first pass from X, Z.
3 Execute the first cut (recessing).
4 Machine perpendicularly to recessing direction (turning).
5 Repeat 3 to 4 until contour end point Z2/X2 is reached.
6 Machine chamfer/rounding at contour start / contour end if
defined.
7 Return to starting point on paraxial path.