HEIDENHAIN MANUALplus 4110 - Manual (Page 438)

438 8 Organization Mode of Operation
8.2 P
a
ra
met
e
rs Control parameters (SP)
Settings [SP 1] Set the system to "metric mode" or "inch mode" and define the
behavior for searching the start block.
„ Output to printer—non-functional
„ Metric/Inch
„ 0: Metric
„ 1: Inch
„ Start block search
„ 0: Off
„ 1: On (Note: The system must be prepared for the start block
function.)
Time calculation for simulation, general [SP 20] The times set in this parameter are taken into account for
calculating the idle machine times.
„ Tool change time [sec]
„ Gear shifting time [sec]
„ Time allowance for M functions [sec]
Time calculation for simulation: M function
[SP 21] For M functions, the control calculates the "time allowance for M
functions" that was defined in parameter 20. In parameter 21, you
can enter up to 10 M functions for which an additional time
allowance is to be calculated.
„ 1st M function
„ Time allowance [sec]
„ 2nd M function
„ Time allowance [sec]
„ . . .
Standard window size [SP 22] These parameters define the display area for the graphic simulation
of DIN programs. MANUALplus accounts for the height and width
of the screen and may even enlarge the window size in the vertical
or horizontal direction.
„ Minimum X coordinate—smallest X coordinate displayed
„ Minimum Z coordinate—smallest Z coordinate displayed
„ Delta X—vertical expansion
„ Delta Z—horizontal expansion
Standard workpiece blank [SP 23] These parameters define the standard workpiece blank and are
used for calculating the "unrolled lateral surface."
„ Outside diameter: The "unrolled lateral surface" is calculated from
the diameter.
„ Length of blank: Horizontal dimension of "unrolled lateral
surface."
„ Right edge of blank part: Position of the unrolled lateral surface
relative to the coordinate origin. If you enter a positive value, the
"right blank edge" is located to the right of the coordinate origin.
„ Inside diameter—non-functional