Undercut din 509 f, 6 thr ead and under c ut cy cles – HEIDENHAIN MANUALplus 4110 User Manual
Page 184

184
4 Cycle Programming
4.6 Thr
ead and Under
c
ut Cy
cles
Undercut DIN 509 F
Call the thread-cutting menu.
Select the "Undercut DIN 509 F" cycle.
With return soft key:
Off: When the cycle is completed, the tool remains at
the cycle end position (see figures at right).
On: Tool returns to the starting point (see figures on
next page).
The cycle machines a thread undercut according to DIN 509 type F, a
cylinder start chamfer, then the adjoining cylinder, and finishes with
the plane surface. You can define a finishing oversize for the area of
the cylinder. The cylinder start chamfer is executed when you enter at
least one of the parameters "B" or "RB."
Cycle parameters
X, Z starting point
X1, Z1 starting point of cylinder
X2, Z2 end point on plane surface
E reduced feed rate
for the plunge cut and the thread chamfer—
default: Feed rate F
T tool number
S spindle speed / cutting speed
F feed per revolution
I undercut depth
—default: Value from standard table
K undercut length
—default: Value from standard table
W undercut angle
—default: Value from standard table
R undercut radius
(on both sides of the undercut)—default: Value
from standard table
P transverse depth
—default: Value from standard table
A transverse angle
—default: Value from standard table
B cylinder start chamfer
—default: No start chamfer
WB 1st cut angle
—default: 45°
RB chamfer radius
—default: No chamfer radius
U finishing oversize
—default: 0
All parameters that you enter will be accounted for—even if the
standard table prescribes other values. If the parameters I, K, W, R, P
and A are not defined, MANUALplus determines these values from
the cylinder diameter in the standard table (see “DIN 509 E, DIN 509
F—undercut parameters” on page 527).